Resistance

Resistance laboratories provide the measurement traceability for resistance as well as development and maintenance of national physical standards for resistance. The laboratories provides calibration measurements with capability  from 1 mΩ to 1 TΩ. The National Standard of Resistance is a 1 Ω and 10 kΩ resistors kept in an oil bath at temperature of 23°C ± 0.001°C. The reference standard resistor is calibrated at BIPM on a regular schedule and disseminate to other resistors by using the automated DCC bridge at range of 1 mΩ to 10 MΩ. Resistance values below 1Ω achieved by using Direct Current Comparator Bridge with a Range Extender. The system has ratios up to 1000:1 with the relative uncertainty of 10-6. The resistance values from above 10 MΩ are scaled up using a modified Wheatstone bridge by replacing Resistive arms with 2 DC Voltage. The resistance laboratories dissemination, capability and uncertainty are shown in following table and diagram respectively. 

        

DC Resistance

:
  • Low range - 1 mΩ to 100 m Ω

  • Medium range - 1 Ω to 10 M Ω

  • High range – 100 MΩ to 1 TΩ

1

Best Measurement Capability

:

    ±0.5 mΩ/Ω to ± 585 mΩ/Ω

                                                            1  Ω standard resistor

DC Current  Shunt

:
  • 1 A to 100 A

 

Best Measurement Capability 

:     ±   5 mA/A to ± 100 mA/A   

2

AC & Low Frequency

AC & Low Frequency Laboratory are capable to generate and measure DC to 10 MHz and beyond covering voltage, current, and resistance parameters to support national AC & Low Frequency measurement activities. The chart illustrates the traceability for AC & Low Frequency in Malaysia.

ac1

The highest standards are primary Thermal Converters and AC DC Shunts maintained by utilizing comparison method of AC-DC. Different comparison methods for accurate RMS value determination of AC Voltage and AC Current at low frequencies are traceable to the national standard of AC Voltage and Current. The frequency range is from 10 Hz to 1 MHz with best uncertainty of 5 uV/V. 

ac1ac2

Thermal Converter

Reference Multimeter

NMIM Info

NMIM plays an important role in disseminating the traceability of measurement to the whole country based on the International System of Units. Just like other world standard laboratories, NMIM has great responsibility in ensuring the national metrology infrastructures meet and comply with the global measurement standards.

Get In Touch

National Metrology Institute of Malaysia (NMIM)
Lot PT 4803, Bandar Baru Salak Tinggi
43900 Sepang
Selangor Darul Ehsan

Corporate inquiries:  irene@sirim.my , 03-87781605                          

Service inquiries:  serviceNMIM@sirim.my , 03-87781604                               

Complaint and feedback: feedbackNMIM@sirim.my

Training course request: NMIMtraining@sirim.my

WhatsApp: +6018–2121 833